Tremec has built a running manual-transmission version of the mid-engine Chevrolet Corvette C8 and let a small group of journalists and potential customers drive it at a private track outside Howell, Michigan.
The C8 was a double break with Corvette tradition: the first Corvette to place its engine behind the driver, and the first sold only with a dual-clutch automatic. The account given of the decision is that a mid-engine manual would have required developing two new transaxles instead of one, an expense that did not fit GM's budget. Faced with a choice between pleasing a very small group of manual enthusiasts and winning comparison tests against far more expensive machinery, executives took the second option.
That produced an excellent and very capable Corvette, but it left buyers who would trade a few tenths in the quarter-mile or on a lap for the pleasure of shifting for themselves with nothing to order. Tremec, which supplies the six-speed manual used in GM performance cars including both Cadillac Blackwings and the discontinued Camaro, kept at the problem. Its manual C8 development car is real, not rumor.
The vehicle used for the drive was a Peitz Performance C8 race car converted to take Tremec's gearbox. It is a one-of-one track build: fully caged, fitted with a racing harness and all but devoid of interior finish. The selector rises from the spot normally occupied by the storage cubby and automatic gear selector.
The conversion proved less invasive than the layout might suggest. The tunnel had to be cut to install the clutch pedal hardware, but the gearbox otherwise sits exactly where the stock dual-clutch unit would, with no special mating parts required. The C8's pedal box, surprisingly, has room to spare for a clutch pedal, and the footwell still feels roomier than a previous-generation Camaro's.
Seat adjustment in the race car is effectively fixed, and set for a driver with longer legs. At 5-foot-7, the driver could not reach the floor to heel-and-toe or brace against anything in corners, which limited how hard the car could be pushed. On a green track on a November afternoon in Michigan, that restraint was probably welcome.
The shift itself is where the mid-engine layout makes itself felt. Because the transaxle sits at the rear, the selector is remotely mounted and connected by cables; a cable can be seen running aft toward the gearbox. Front-engine cars using Tremec's TR-6060 and its predecessors link the shifter mechanically and directly to the transmission, with nothing in between. The transaxle therefore feels a little less precise and less snick-snicky, and less notchy, than its front-engine cousin. Some drivers will prefer the smoothed-off edges; others will miss the more mechanical feel. The only fixes would be moving the engine forward, which yields a C7, or moving the shifter rearward to roughly where the C8's engine is mounted.
Cost is the larger obstacle. Tremec puts the gearbox alone at about $75,000, which, added to the price of a Corvette, pushes a converted manual C8 toward the sticker of a showroom-spec Z06. The company says that figure will come down as volume increases. It also says automakers are interested — not necessarily, and certainly not exclusively, General Motors. The gearbox was engineered to fit the C8, but other manufacturers have asked about a high-torque manual transaxle, according to Tremec. No names have been disclosed.
